|
|
|
|
|
|
|
|
|
|
||||||
|
|
|
|
|
|
|
|
|
|
||||||
 |
|||||||||||||||||||||||
| AP AUTOMATION
MAGNETIC PROBES All probes include simple, secure mounting provisions and can attach to most welding torches in minutes. Water-cooling hoses (where required) and probe cables are part of each probe assembly. See the controller/probe compatibility chart for system details. |
|||||||||||||||||||||||
 |
MP-100 PROBE The MP-100 probe incorporates the latest magnetic technologies. Though similar to the MP-1 probe, the new MP-100 probe has a much higher gauss strength and three times the efficiency of the MP-1. The MP-100 does not require water cooling; however, it does allow for optional water cooling. |
||||||||||||||||||||||
For added convenience and flexibility, it also features a detachable control cable. Single-axis probe adapts to conventional torches. A variety of return rings and tips are available for different configurations. Watch a video of the MA-20 and the MP-100 controlling a 350-amp arc. |
|||||||||||||||||||||||
|
MP-1 PROBE The MP-1 is a single-tip, water-cooled probe that adapts to conventional torches. The MP-1 works well in tight clearances and is primarily used to weave the arc across the seam or to stabilize the arc. |
||||||||||||||||||||||
| MP-2
PROBE The dual-tip MP-2 slips over a conventional TIG torch and can be used either for cross-seam weaving or in-line weaving. In-line weave is primarily used in tube mills to preheat the tube, giving increased weld travel speeds. |
 |
||||||||||||||||||||||
 |
MP-22 PROBE Use the MP-22 probe with the MA-20 control unit only. This twin-tip side-mount unit is capable of delivering the full 600 gauss magnetic field to the welding arc area. Though normally used in an air-cooled mode, if necessary, the MP-22 can also be water-cooled. |
||||||||||||||||||||||
| MP-4
PROBE With four independently controlled magnetic coils, the MP-4 probe has the highest capacity for multiple arc and weld bead profiles. It is used with the MA-40 control unit only. |
 |
||||||||||||||||||||||
| The AP Automation MA-40 Control Unit and MP-4 Probe provide the ability to shift the entire arc pattern relative to the weld seam with position controls, as shown below. | |||||||||||||||||||||||
 |
|||||||||||||||||||||||
|
|||||||||||||||||||||||
|
|||||||||||||||||||||||
|
|||||||||||||||||||||||
